Sensorberg

No wiring required
No electric contact in the cylinder
According to DIN 18252 and DIN EN 1303, as far as applicable to electronic systems
Certified as per DIN EN 15684
Suitable for integration into profile cylinder locks
Suitable for installation in fire and smoke resistant doors
2 batteries CR2 Lithium 3V for the knob module
2,4 GHz Bluetooth® Low Energy
Supports MIFARE Classic®, MIFARE® DESFire
Up to 100,000 actuations during one battery life cycle
External power supply possible, if batteries are empty
Suitable for indoor and outdoor use.

Temperature range:
+5° C to +55° C (Indoor version) (IP65)
-25° C to +65° C (Outdoor version) (IP66)

2122: Length of the Knob: 42,7 mm*
2122: Diameter of the Knob: 40,0 mm*
2122: Dimensions of the Mechanical Knob: Version A: Length = 20,0 mm, Ø = 29.0 mm / Version B: Length = 20,0 mm, Ø = 34,0 mm
2122: Possible lengths of cylinders from 26/26 mm and/or 30/30 mm, 40/30 mm to 200/200 mm in 5 mm steps
2124: Length of the Knob: 42,7 mm*
2124: Diameter of the Knob: 40,0 mm*
2124: Profile cylinder lengths from 35/35 mm to 200/200 mm in 5 mm steps
2126: Length of the Knob: 42,7 mm*
2126: Diameter of the Knob: 40,0 mm*
2126: Possible lengths of cylinders from 26/10 mm and/or 30/10 mm to 200/10 mm in 5 mm steps

*Dimensions do not apply to version for exterior doors

General assembly instructions

Before assembling the CX212x knob cylinder in a fire/smoke-resistant door, please recheck the fire certification to ensure conformity.
Ensure that the sealing affixed on the door does not hamper proper operation of the CX212x.
Ensure that the knob cylinder projections do not obstruct the free swing of the door.
As electronic knob cylinders are supplied in a completely assembled state as standard, it may be necessary to perform the steps for disassembly, asdescribed in chapter 4.3, before mounting.
To activate the knob module, insert the batteries or remove the battery tag, if present, and close the casing (see chapter 7.2.1 Changing batteries).
Before mounting the knob module, always check that all components move freely.
Carry out the assembly with the door open.
Only for cylinders supplied as single components: During initial installation, put in 1 to 2 drops (max. 0.1 ml) of a non-resinous oil in the cylinder body.It should not be sprayed directly into the cylinder body with a spray can.

Product Details